Pix User Manual

  • Welcome to Pix
  • Installation
  • User Interface
  • Toolbar overview
  • Toolbar commands
    • Selection
      • Pick
      • Measure
    • Draw
      • Line
      • Parallel line
      • Perpendicular line
      • Arc
      • 2-Point arc
      • 3-Point arc
      • Tangent-Point arc
      • Point
    • Draw shapes
      • Circle
      • 2-Point circle
      • 3-Point circle
      • Rectangle
      • Center-Point rectangle
      • Inscribed polygon
      • Circumscribed polygon
      • Edge polygon
    • Edit edges
      • Fillet
      • Chamfer
      • Inside fillet
      • Corner step
      • Edge recess
      • Edge U-Cut
      • Edge V-Cut
      • Key slot
    • Modify
      • Move
      • Rotate
      • Scale
      • Mirror
      • Rectangular array
      • Polar array
      • Trim
      • Extend
    • Dimensions
      • Linear Dimension
      • Baseline Dimension
      • Continue Dimension
      • Angle Dimension
      • 3-Point Angle Dimension
      • Radius Dimension
      • Diameter Dimension
      • Callout Dimension
      • Segment Dimension
    • Cleanup
      • Join
      • Decurve
      • Remove Small Segments
      • Mark Open Polylines
      • Highlight Overlaps
      • Mark Non-Tangent Corners
      • Mark Large Radius
    • Setup
      • Layer Setup
      • Shift Origin
  • Demo Videos
Demo Videos

Demo Videos

Watch the demonstration video to get an overview of how PIX works.

Join Lines

Remove Small Segments

Shift Origin

      Copyright © 2025 TRUMPF Metamation. All rights reserved.

    Compiled by Bento